Hobbywing Seaking-25A User Manual download pdf

User Manual of ³SEAKING´ Series Brushless Speed Controller for Boat HW-SM701DUL-20130610 Page - 1-

Thanks for purchasing ³6($.,1*´VHULHV Electronic Speed Controller (ESC) for boat. High power system for RC

model can be very dangerous, so please read this manual carefully. In that we have no control over the correct

use, installation, application, or maintenance of our products, no liability shall be assumed nor accepted for any

damages, losses or costs resulting from the use of the product. Any claims arising from the operating, failure of

malfunctioning etc. will be denied. We assume no liability for personal injury, consequential damages resulting

from our product or our workmanship. As far as is legally permitted, the obligation to compensation is limited to

the invoice amount of the affected product.

Features

Ź Specially designed for RC boat, with excellent start-up, acceleration and linearity features.

Ź Use top quality electronic components to enhance the current endurance ability of the ESC.

Ź With water cooling heat-sink, the ESC is splash-proof (Note: Not 100% water-proof).

Ź UXQQLQJPRGHV³)RUZDUG2QO\´PRGHDQG³)RUZDUG%DFNZDUG´PRGH for various of boats.

Ź Multiple protection features: Low voltage cut-off protection for lithium or nickel battery / Over-heat protection /

Throttle signal loss protection.

Ź 8 steps of timing adjustment, compatible with all kinds of sensorless brushless motor.

Ź Pocket-sized Program Card can be purchased separately for easily setting the programmable items.

Note1: The program card is an optional equipment for the ESC.

Specifications

ǏBegin To Use The New ESCǐ

Warning! For safety, please always keep the propeller away from human body or any other object.

STEP #1. Connect the ESC, motor, receiver, battery and servo according to the following diagram.

The output wires of A, B, C of the ESC can be connected with the motor wires freely (without any order). If the motor runs

in the opposite direction, please swap any two wire connections.

STEP #2. Throttle Range Setting (Throttle Range

Calibration)

In order to make the ESC fit the throttle range, you

must calibrate it for the following cases; otherwise the

ESC cannot work properly.

Ź Begin to use a new ESC;

Ź Begin to use a new transmitter;

Ź Change the settings of neutral position of the

throttle stick, ATV or EPA parameters, etc.

The Normal Start Process

1. Move the throttle stick to the neutral position or the bottom position, and then turn on the transmitter.

2. Connect the battery pack to the ESC.

3. 7KHPRWRUHPLWVVHYHUDO³%HHS´WRQHVWRUHSUHVHQWWKHFHOOVQXPEHURI\RXUOLWKLXPEDWWHU\SDFN3OHDVHPDNHVXUH

that the number is correct. If only one ³%HHS´WRQHLVHPLWWHGWKDWPHDQVWKH³/RZ9ROWDJH&XWRII7KUHVKROG´3OHDVH

UHIHUWRWKH³3URJUDPPDEOH,WHPV´LQWKHfollowing formLVVHWWR³1RSURWHFWLRQ´WKLVLVRQO\VXLWDEOHZKHQ\RXDUH

XVLQJD1L0+EDWWHU\SDFN3OHDVHQHYHUXVH³1RSURWHFWLRQ´PRGHIRUOLWKLXPEDWWHU\RWKHUZLVHWKHEDWWHU\LVYHU\

easy to be damaged.

4. Move the throttle stick upwards, the motor begins to run and speeds up.

The LED Status

There is a red LED in the ESC, the usages are:

1. The LED lights when the throttle stick is moved to the maximum position (full throttle).

2. When setting the throttle range or setting the programmable items of the ESC, the LED flashes at the same time

when the motor beeps.

Programmable Items

Note2: The italics texts in the following form are the default settings.

Note3: Seaking-130A-+9RQO\KDVRSWLRQ)RUZDUG2QO\LWKDVQ¶WRSWLRQ)RUZDUGDQG%DFNZDUG 

Note4: The parameters in this line are available for normal voltage ESC (Supports 2-6 cells lipo)

Note5: The parameters in this line are available for high voltage ESC (Supports 5-12 cells lipo)

1. Running Mode: :LWK ³)RUZDUG 2QO\´ PRGH WKH ERDW FDQ JR IRUZDUG EXW FDQQRW JR EDFNZDUG ³)RUZDUG DQG

Backward´PRGHSURYLGHVEDFNZDUGIXQFWLRQZKLFKLVVXLWDEOHIRUVRPHVSHFLDlly designed boats. Please read the

user manual of your boat to confirm whether it is possible to run backward.

2. Lipo Cells: :HVWURQJO\VXJJHVWVHWWLQJWKH³/LSR&HOOV´LWHPPDQXDOO\ ,I\RXFKRRVH³$XWR&DOFXODWH´WKH

(6&ZLOOPHDVXUHWKHEDWWHU\¶VYROtage when it is just connected, and then the ESC judges the cells number. For

H[DPSOHLIWKHEDWWHU\¶VYROWDJHLVORZHUWKDQ9LWZLOOEHMXGJHGDVFHOOV/LSREDWWHU\,QRUGHUWROHWWKH(6&

2.2 If you are using a Handgun-style transmitter:

a) Move the throttle stick to the maximum position

(that is: full throttle position), and then connect the

EDWWHU\ SDFN WR WKH (6& DIWHU  VHFRQGV³%HHS-

Beep- ´ WRQH can be heard, that means the full

throttle position has been confirmed.

b) Release the throttle stick to the neutral position,

D³%HHS´WRQHFDQEHKHDUGWKDt means the neutral

position has been confirmed.

Now the throttle range setting process is finished.

³%HHS- Beep-´³%HHS-´

1RWH:KHQWKHPRWRUHPLWV³%HHS´WRQHWKHUHG/('

in the ESC will flash at the same time.

2.1 7XUQRQWKHWUDQVPLWWHU VHW WKH ³(3$$79´YDOXHRIWKURWWOHFKDQQHOWR³´DQG GLVDEOH WKH ³$%6´EUDNH

function of your transmitter if it does has this function. If you are using a Futaba transmitter, please set the

direction of the WKURWWOHFKDQQHOWR³5(9´

1 2 3 4 5 6 7 8

1. Running Mode Note3

Forward Only

Forward and

Backward

2. Lipo Cells Note4

Auto Calculate 2 cells 3 cells 4 cells 5 cells 6 cells

Note5 Auto Calculate 5 cells 6 cells 8 cells 10 cells 12 cells

3. Low Voltage Cutoff Threshold No Protection 2.8V/Cell 3.0V/Cell 3.2V/Cell 3.4V/Cell

4. Timing 0.00° 3.75° 7.50° 11.25° 15.00° 18.75° 22.50° 26.25°

Value

Programmable Items

25A SEAKING-25A 25A 50A Linear 6V/1.5A 2-3 5-9 48g Ɏ 48*35*20

35A SEAKING-35A 35A 70A Linear 6V/1.5A 2-3 5-9 50g Ɏ 48*35*20

60A SEAKING-60A 60A 120A Switch 6V/3A 2-6 6-18 76g Ɏ 94*33*18

90A SEAKING-90A 90A 180A Switch 6V/3A 2-6 6-18 81g Ɏ 94*33*18

120A SEAKING-120A 120A 240A Switch 6V/3A 2-6 6-18 91g Ɏ 94*33*18

180A SEAKING-180A 180A 360A Switch 5.8V/3A 2-6 6-18 165g Ɏ 72*68*34

80A-HV SEAKING-80A-HV 80A 160A None None 5-12 15-36 91g Ɏ 94*33*18

130A-HV SEAKING-130A-HV 130A 180A None None 5-12 15-36 182g Ɏ 88*58*23

Battery Cells

Lipo NiMH

Size

L*W*H

High Voltage ESC ( Supports 5-12 cells Lipo )

Cont.

Current

Water

Cooling

Pipe

Burst

Current

(10s)

WeightBEC

Mode

BEC

Output

Normal ESC ( Supports 2-6 cells Lipo )

Class Model

2.2 If you are using a Flat-style transmitter:

a) Move the throttle stick to the top position (that

is: full throttle position), and then connect the

battery pack to the ESC, aftHUVHFRQGV³%HHS-

Beep- ´ WRQH FDQ EH KHDUG WKDW PHDQV WKH IXOO

throttle position has been confirmed.

b) If you want to set it to half-range, please move

WKHWKURWWOHVWLFNWRWKHQHXWUDOSRVLWLRQD³%HHS´

tone can be heard, that means the neutral

position has been confirmed.

If you want to set it to full-range (In such a case,

the boat cannot run backward), please move the

WKURWWOHVWLFNWRWKHERWWRPSRVLWLRQD³%HHS´WRQH

can be heard, that means the bottom position

has been confirmed.

Now the throttle range setting process is finished.

³%HHS- Beep-´³%HHS-´

1RWH :KHQ WKH PRWRU HPLWV ³%HHS´ WRQH WKH UHG

LED in the ESC will flash at the same time.

1 2

1 2 3 4 5 6 7 8 1
Programmable Items 1

Summary of Contents

Page 1 - Programmable Items

User Manual of ³SEAKING´ Series Brushless Speed Controller for Boat

Page 2

User Manual of ³SEAKING´ Series Brushless Speed Controller for Boat

Comments to this Manuals

No comments

Hobbywing Seaking-25A User Manual

Browse online or download User Manual for Toys Hobbywing Seaking-25A. Hobbywing Seaking-25A User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Toys Hobbywing Seaking-25A